How to make patterns yourself

[Johnson 778]

More and more often we are asked questions about making templates.

 

- What can be done if there are no patterns for particular parts in the database?

 

This week we have received three requests from car owners who would like to cover with film the entire car including doors and the rear bumper. In this article I will reveal one of the ways of making patterns yourself. To begin with, you need a permanent marker with the thickness of 0.3 mm., mounting film or paint protection film, a squeegee and some patience.

 

 

Roll out the mounting film on the varnish-and-paint surface. Do it without any bubbles or folds. The main point is not to hurry. Having rolled out the film, slowly draw a thin line on the edge of the element with a marker. It will later become the edge of the film. If you choose a thicker marker, the inaccuracy will be higher. Nowadays, everyone tries to install the film turned under the hood, arch etc. Do not tuck film if it takes less than 10 mm. as the film is likely to rise due to lack of adhesion space. If the element has a spherical shape and the mounting film folds in any case, make it out of two parts joint to joint or cut along the fold, having put the small folds into

a big one.

 

 

 

 

 

 

 

Carefully take away the template from the varnish-and-paint surface not tearing or stretching it.

 

 

 

Now that the template is ready, take the squeegee, roll out the mounting film with a pattern without any bubbles and folds on the paint protection film and cut with an Olfa knife. If you are a novice installer, this is the only way of making a pattern...do not try to cut film with a knife on a car unless you have been taught by a Japanese samurai or a ninja

 

 

The more experienced installers roll the patterns out on a film substrate in order to scan them and draw in CorelDraw. Of course, you have to cut manually if there is not a plotter or a scanner. Drawing templates in the vector editor requires time and effort, but it later speeds up the process of cutting if you have a high flow of vehicles.

 

 

Once the template is ready, for final adjustments we make a pattern of paper with the help of a plotter and a marker.

 

 

 

Next, check by putting it on a slightly moistened car surface...

 

 

 

 

Installing film...

 

 

 

 

 

Dry the tucks properly. Some installers to be safe use a primer for a better grip. Nevertheless, small stains usually remain but they are not seen on the tucks. If the glue is not strong, the edge can be covered with more transparent sealant, which will eventually wash away but will protect the edge from pulling up.

 

 

 

Final result.

 

 

 

This is the easiest and the most versatile way. There are ways of making patterns in one piece without any joints under film tension, but they require extra experience and knowledge. The novice will not be able to cope with this. If you have any questions, do not hesitate to ask.